Answer the following statement(s) true (T) or false (F)

1. Use of pressure drop charts based on 60° F water will consistently overestimate the pressure drop in hydronic piping circuits because the water will usually be at higher temperatures.
2. The equivalent length of a component is the amount of tubing, of the same pipe size, that would produce the same head loss (or pressure drop), as the actual component, at the same flow rate.
3. The equivalent hydraulic resistance of an entire assembly is always greater than the smallest individual hydraulic resistance.
4. Determining the flow rates in systems with several parallel branches does not require “number crunching.”
5. Every piping system should be thought of as having an operating cost as well as an installation cost.


1. True
2. True
3. False
4. False
5. True

Trades & Technology

You might also like to view...

To convert a fraction to a decimal, divide the numerator by the ____________________.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

Passive solar devices are primarily used to heat water

Indicate whether the statement is true or false.

Trades & Technology

Oil must never be used around a(n) ____________________ cylinder.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

Smoke detectors should be placed on the ceiling or high on a wall. Dead air spaces should be avoided. Where does dead air spaces occur?

A. in the middle of the ceiling B. all areas of the room above 6 feet C. the four sides of a room where the walls meet each other D. at the top edge of a room where the ceiling and wall meet.

Trades & Technology