The types of pipe, flanges, valves, bolts, and gaskets required for the pipe run are usually included in an isometric drawing in a _____.

a. line list
b. bill of material
c. drawing index
d. piping list


b. bill of material

Trades & Technology

You might also like to view...

Refer to Exercise 19.

a. Find .
b. Find .
c. Find .
d. Find .
e. Find Cov(X,Y).
f. Find .

Trades & Technology

Which of the following two cold-formed steel (CFS) stud walls has a higher R-value? Both walls consist of 3-1/2-in.-deep studs and 3-1/2-in.-thick fiberglass insulation. In wall 1, the studs are spaced 24 in. on center and in wall 2, they are spaced 12 in. on center.

What will be an ideal response?

Trades & Technology

President Cleveland's hostility to silver and silver-backed currency was driven primarily by his fear that

A. the growing drain of gold from the U.S. Treasury would force the United States off the gold standard. B. the unlimited supplies of silver within the United States would cause an extended depression. C. supporting free silver would be politically beneficial to Democrats such as William Jennings Bryan. D. soon gold and silver would both be replaced by strictly paper currency. E. the U.S. Treasury did not have sufficient capacity to store silver bullion at Fort Knox.

Trades & Technology

Which of the following represents a different temperature than the other three?

A. 15°C B. 59°F C. 475°K D. 519°R

Trades & Technology