Write a step-by-step procedure sheet for preparing an e-coated part for refinishing.
What will be an ideal response?
To be sure that a finish is E-coat, a solvent test should be performed. Once the test confirms that the coating is thermoset, the normal preparation can be completed:
? Clean with hot water and soap.
? Clean with a wax and grease remover.
? Scuff with a red sanding pad, using a sanding paste.
? Deglaze the entire surface to be refinished. Seal the topcoat as needed for edging.
You might also like to view...
What would be the best to use when monitoring the temperature of a new engine that has just been started?
A. scan tool B. factory gauge C. warning indicator D. pyrometer
You should always use _____ when using a table saw to rip boards less than 4" wide
a) hold-downs b) a push stick c) a miter gauge d) an auxiliary fence
The tool that will MOST-Likely ask you to check a wheel speed sensor for AC voltage output is the:
A. lateral acceleration sensor B. antilock brake controller C. wheel speed sensor D. diagnostic flow chart
Funds used to pay bills are called _____
A) working capital B) loans C) ?initial funding D) fixed assets