This type of view may be used when part of a view has detail that cannot be clearly dimensioned because of the print scale or complexity.
a. large view
b. partial view
c. detail view
d. section view
c. detail view
You might also like to view...
Cartridge fuse and fuseholder overcurrent protection provisions are located in ____.
A. 240.12 B. 240.21 C. 240.60 through 240.67 D. 404.8 and 404.13
Technician A says the engine breathes through the intake and exhaust systems. Technician B any restriction in intake or exhaust system will negatively affect an engine's performance. Who is correct?
A. Technician A B. Technician B C. Both A and B D. Neither A nor B
The minimum end bearing of an open-web joist on a steel-bearing plate with no embedded anchors on a
concrete or masonry wall is _____. a. 2-1/2 inches b. 4 inches c. 5 inches d. 8 inches
Radon protection, plumbing, wiring, and insulation should be installed ________ the slab is finished
A) During B) Before C) After