In the formula for cutting and forming tools, angle A is the given angle in the ____________________ view (horizontal plane) in relation to the frontal plane.

Fill in the blank(s) with the appropriate word(s).


top

Trades & Technology

You might also like to view...

¿Cuál de las siguientes operaciones se realiza comúnmente con una grapadora neumática en lugar de una clavadora?

a. Instalación de terminaciones b. Instalación de aislantes c. Construcción de armarios d. Instalación de estructuras interiores

Trades & Technology

Answer the following statement(s) true (T) or false (F)

Sixty-four independent measurements were made of the speed of light. They averaged 299,795 km/s and had a standard deviation of 8 km/s. a. A 95% confidence interval for the speed of light is 299,795 ± 1.96 km/s. b. The probability is 95% that the speed of light is in the interval 299,795 ± 1.96. c. 95% of the measurements were in the interval 299, 795 ± 1.96. d. If a 65th measurement is made, the probability is 95% that it would fall in the interval 299,795 ±1.96.

Trades & Technology

On a commercial refrigeration system with electric defrost, what does the evaporator fan do during the defrost cycle?

A) It runs backwards to reverse the airflow. B) It cycles like it normally would. C) It operates to circulate warm air over the evaporator coils. D) It shuts off.

Trades & Technology

How are steel ring connectors shown in standard practice? ________________

Fill in the blank(s) with correct word

Trades & Technology