How would you use the Scale tool to shrink an object in both the red and green directions, without using the tool more than once?
What will be an ideal response?
Shrink the object by using one of the drag handles as shown in Figure 5-23, pressing Ctrl / Option to scale about the center. Stop to end the operation anywhere, then use the value – comma – value format to specify the scale value in both directions
You might also like to view...
What is the purpose of this component (arrow) in this schematic?
A) To protect the ground connection B) To control voltage spikes C) To protect the relay incase of reverse polarity D) To hold the relay on once it is energized
The diameter of a cylinder is called the ________
A) Bore B) Stroke C) Radius D) Diameter
The burner motor runs, but the oil pump does not produce pressure. This can be caused by:
A) A defective burner motor centrifugal switch. B) A plugged oil nozzle. C) A defective ignition transformer. D) A defective oil pump drive coupling.
If the thermal bulb assembly develops a leak, what will occur?
A. All of the system's refrigerant will leak out. B. The bulb pressure will reduce and the valve will close. C. The valve will open to allow more refrigerant to flow. D. It will have no effect on system operation.