Given a workpiece diameter of 67.75 mm turning at 500 revolutions per minute, what is the cutting speed C? Use C = 3.1416DN/1000 and round to the nearest whole number.
A. 100
B. 107
C. 105
D. 106
Answer: D
Trades & Technology
You might also like to view...
The phrase pairs of poles is used to indicate that ____ poles are always in pairs.
a. reduction b. motor c. squirrel d. cage
Trades & Technology
There are ____ basic types of multispeed single-phase motors.
a. two b. three c. four d. five
Trades & Technology
Which type of port fuel injection groups the injectors into two groups, with each group firing once per crankshaft revolution?
A) Simultaneous double fired B) Sequential fired C) Throttle body injection D) Gang double fired
Trades & Technology
A common-drain amplifier is characterized by
A) low input impedance—high output impedance B) high input impedance—high output impedance C) low input impedance—low output impedance D) high input impedance—low output impedance
Trades & Technology