Activity sampling is the practice of observing and classifying _____.

a. a small percentage of a total activity
b. resource control measures on site
c. discrepancies in overtime labor hours
d. the number of daily units produced


a. a small percentage of a total activity

Trades & Technology

You might also like to view...

Which of the following is the largest value of resistance?

A. The total resistance of two 1k ohm resistors connected in series B. The total resistance of two 1k ohm resistors connected in parallel C. 1000 ohms D. 100,000 milliohms

Trades & Technology

The free fall test is a standard check for ________.

A) Accumulators B) Check balls C) Shift solenoids D) Shift valves

Trades & Technology

The ____ bearings are the physical connection between the stationary stator, and the rotating rotor, and the only wear point on three-phase induction motors.

a. torque b. motor c. stator d. power

Trades & Technology

What term is used to describe combustion gasses leaking past cylinder rings?

A) Crankcase build-up B) Sludge C) Manifold pressure D) Blow by

Trades & Technology