When testing an ECT sensor on a vehicle, a digital multimeter can be used and the signal wires back probed. What setting should the technician use to test the sensor?
A) AC volts
B) Ohms
C) Hz (hertz)
D) DC volts
D
You might also like to view...
When designing a device or a system, the engineer must keep certain factors in mind, which are usually related to the ____ and cost of the resulting system.
A. function B. environmental impact C. location D. production
The first step in sketching an isometric drawing of a brick is to ____.
A. sketch a Y B. sketch the bottom edges C. mark off the width D. mark off the length
A variety of written communications displayed publicly in a permanent or semi-permanent manner would known as _______
A) Point-of-purchase B) Merchandising locations C) Signage D) None of the above
The level of the building?s floors and walls will be affected if the sill plate is _____
a. too thick b. not level c. not plumb d. warped or bowed