To properly set the heat anticipator, the ____ must determine what the current flow is through the heating control circuit when the furnace is operating in a steady state condition.
A. manufacturer
B. homeowner
C. electrician
D. heating technician
Answer: D
You might also like to view...
What are the five major kinds of rivets?
What will be an ideal response?
A rear-wheel drive vehicle shudders or vibrates when first accelerating from a stop. The vibration is less noticeable at higher speeds. The most likely cause is ________
A) Brinelling of the U-joint B) Drive shaft imbalance C) Unequal U-joint working angles D) Excessive U-joint working angles
Technician A says primary vibration is created by the slight differences in the inertia of the pistons between top dead center and bottom dead center. Technician B says secondary vibration is a strong low-frequency vibration caused by the movement of the piston traveling up and down in the cylinder. Which technician is correct?
A) Technician A B) Technician B C) Both technicians D) Neither technician
Using the Zeigler-Nichols tuning method, the proportional setting for the proportional-only mode will be different than the proportional setting for the proportional-plus-integral control mode.
Answer the following statement true (T) or false (F)