If a joint is struck or tooled while the mortar is too soft, the joint will be _____ .
A. fatigued
B. too sharp
C. wet or runny
D. unable to be fixed
Answer: C
You might also like to view...
In some hybrid electric vehicles, the wide band oxygen sensor can cause the PCM to enter closed loop ________
A) Within 10 seconds of engine (ICE) start-up B) As soon as the engine (ICE)starts C) Within 2 minutes D) By the time the vehicle reaches 60 mph
Titanium nitride coatings give high lubricity to the tool surface, which facilitates chip flow and resists built-up edge during machining
Indicate whether the statement is true or false
The first step in the process of shutting down a skid-steer loader is to _____
a. set the parking brake b. lower the bucket so it is flat on the ground c. cycle the hydraulic controls to release pressure d. place the operator controls in neutral
If a bay window is to be included on the floor plan, special consideration will be required to draw the roof covering it.
Answer the following statement true (T) or false (F)