Name and describe the method used to locate sectional views on a sheet other than where the cutting plane lines appear.

What will be an ideal response?


When necessary, locate sectional views on a sheet other than where the cutting plane lines appear. The method for doing this is called cross-reference zoning and is used to indicate the location of a section back to the viewing location on a previous page. The sectional view is located on a different page and is labeled with the sheet number and zone of the cross-reference cutting plane. ASME Y14.3 does not recommend a specific zone and page identification system. The cutting plane and sectional views should have a note correlating each between sheets.

Trades & Technology

You might also like to view...

PROBLEM 3.132 Shafts A and B are made of the same material and have the same cross-sectional area, but A has a circular cross section and B has a square cross section. Determine the ratio of the maximum shearing stresses occurring in A and B, respectively, when the two shafts are subjected to the same torque (TA = TB). Assume both deformations to be elastic.

Trades & Technology

Write the general chemical formula for the dilution correction factor.

What will be an ideal response?

Trades & Technology

When is the Y terminal energized on most heat pump thermostats?

A) Anytime the system is energized B) In first stage cooling only C) Both first-stage heating and cooling D) In first stage heating only

Trades & Technology

The typical boxed cornice is a boxed cornice with level soffits formed by short sections of vinyl called ________

A) Eave troughs B) Break metal C) F-channel D) Soldier courses

Trades & Technology