Drawings of nonstandard parts included in a parts list are called:
A. Detail drawings
B. Detailed drawings
C. Sub-assembly drawings
D. Assembly drawings
Answer: A
You might also like to view...
The front wheel bearings are being replaced on a front-wheel-drive vehicle with the wheel bearings pressed into the steering knuckle. Technician A says the vehicle should be driven a short distance in the shop before the front hub nuts are torqued to specifications. Technician B says the hub nut torque supplies the correct wheel bearing adjustment. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B
In the accompanying figure, the item identified as number 2 is a ____ representation.
A. pictorial B. simplified C. reference D. schematic
Typical secondary coil resistance specifications usually range from ________ ohms
A) 6,000-30,000 B) 500-1500 C) 100-450 D) 1-3
Failure to properly ground the ignition module on a gas furnace may result in _____
a. flame sensor burnout b. high igniter current c. failure of the flame sensor to function d. excessive flame rectification