Which of the following enables you to control the behavior of very specific areas on the surfaces of lofted 3D objects?
a. Using a path
b. Using draft angles
c. Using guides
d. None of the above
C
You might also like to view...
Soft copper tubing is _____ than drawn copper tubing.
a. heavier b. more expensive c. less brittle d. more likely to split when flared
An existing Class II two-lane highway is to be analyzed to determine the level of service in each direction given the following information:
Peak hourly volume in the analysis direction: 900 veh/h Peak hourly volume in the opposing direction: 400 veh/h Trucks: 12% of total volume Recreational vehicles: 2% of total volume PHF: 0.95 Lane width: 12 ft Shoulder width: 10 ft Access points per mile: 20 Terrain: rolling Base free flow speed: 60 mi/h No passing zones: 40% of analysis segment length What will be an ideal response?
When refueling a CNG vehicle, why is it recommended that the tank be filled to a high pressure?
A) The range of the vehicle is increased B) The cost of the fuel is lower C) Less of the fuel is lost to evaporation D) Both A and C
The concept that some parts vary in form beyond the MMC size limits after manufacture is:
A. tangent plane B. projected tolerance zone C. free state variation D. between symbol