Which of the following combinations of group performance norms and cohesiveness is best
from the manager's point of view?
a. Low cohesiveness/low norms
b. Low cohesiveness/high norms
c. High cohesiveness/low norms
d. High cohesiveness/high norms
D
You might also like to view...
The rebar-tying method shown in the figure above is called a _____.
a. wrap-and-tie b. standoff tie c. bar hitch d. nail-head tie
Which of the following meshes is fabricated from a single sheet of metal?
a. Hex mesh b. Lattice mesh c. Metal fiber mesh d. Expanded metal mesh
All of the following statements are true EXCEPT:
A. on a late-model car running at 2,000 rpm with a hot converter, normal readings from the exhaust pipe should be above 0.1% (with an air injection system disabled). B. like HC, O2 is not formed during combustion so it should be consumed during each combustion cycle. C. before combustion, the incoming air is 21% O2. D. when checking O2 emissions in the exhaust, it is very important that there be no supplemental air or exhaust system leak.
A catalytic converter is being tested with an infrared pyrometer. Which is an acceptable result?
A) The outlet should be hotter than the inlet by 10% B) The temperature of a catalytic converter is the best test to perform to locate a restricted unit C) Both the inlet and outlet should be the same temperature after the converter reaches operating temperature D) The inlet should be hotter than the outlet by 10%