Use a _______ to measure the shift forks.

A. vernier caliper
B. dial gauge
C. feeler gauge
D. snap gauge


Answer: A

Trades & Technology

You might also like to view...

A typical hand-crank wire puller, using 30 pounds of force, can pull up to _____.

a. 300 pounds b. 800 pounds c. 1,500 pounds d. 4,000 pounds

Trades & Technology

Only ____-phase motors are suitable for use with VFDs.

a. one b. two c. three d. four

Trades & Technology

The Otto cycle efficiency is nearest:

The pressure and temperature at the inlet to the ideal Otto cycle, with T-s diagram shown, are 100 kPa and 10ºC. The maximum temperature in the cycle is 1200ºC. Assume constant specific heats from Table below for all calculations.

A) 49%
B) 54%
C) 58%
D) 63%

Trades & Technology

Which of the following is not a type of compound motor?

A) Integrator B) Cumulative C) Differential D) Interpole

Trades & Technology