Refer to Figure P2.13. Assume R0 = 1?, R1 = 2?, R2 = 3?, R3 = 4?, and vS = 10V. Use KCL and Ohm’s law to find the unknown currents.



Find:

a) i0 b) i1 c) i2 d) i3


Analysis:

Trades & Technology

You might also like to view...

What is the heat load in a cooling tower that circulates 30,000 GPM with cooling water exiting the tower at 70 degrees F and the warm cooling water returning to the tower at 95 degrees F?

A. 750 MBTUs/min B. 4,998 MBTUs/min C. 6,247 MBTUs/min D. 7,497 MBTUs/min

Trades & Technology

When making the bird's mouth cut, its depth should not exceed _____.

a. one-third the rafter's width b. the rafter's thickness c. one-fourth the rafter's thickness d. the depth of the top plate

Trades & Technology

What engine was the first generation of DDEC electronics (DDEC I) used on?

A. Series 92 B. 60 Series C. 55 Series D. 50 Series

Trades & Technology

Most manufacturers recommend that brake parts should be cleaned with ________

A) Detergent and water B) Denatured alcohol C) Stoddard solvent D) Clean water only

Trades & Technology