Use the following information to solve problems 7 through 10. A drafter must determine several measurements before a gear can be drawn. These measurements are often found by using formulas. Most gear-cutting data can be found if the diametral pitch P and the number of teeth N are known. Given the diametral pitch P is 8, and the number of teeth N is 96, use the following formulas to solve the problems.a. Pitch Diameter D:  b. Outside Diameter O:  c. Addendum A: 

src="https://sciemce.com/media/4/ppg__examview__ch32__00001_res__sa007-3.jpg" border="0">d. Thickness of the Gear Tooth T:    e. Depth of the Gear Tooth W:    Find the pitch diameter D.

What will be an ideal response?

---

12 inches

Trades & Technology

Single insulated feeder and branch circuit conductors may be used to supply power for temporary testing, emergencies, experiments, and developmental work where accessible _____.

a. to the general public b. to qualified persons only c. during daytime hours d. to a 600V service

¿En qué capítulo del NEC® podría encontrar tablas a las que otros capítulos hicieron referencia?

a. Capítulo 6 del NEC® b. Capítulo 9 del NEC® c. Capítulo 8 del NEC® d. Capítulo 7 del NEC®

Proper nutrition is less important in animals than it is in humans

Indicate whether the statement is true or false.

Which of the following factors determine the synchronous speed of an AC motor?

A. inductance of the rotor windings B. the frequency of the applied voltage C. the number of field poles per phase D. the physical load driven by the motor E. both b and c