A technician is performing a wire repair on a circuit under the hood of a vehicle. Technician A says to use solder and adhesive-lined heat shrink tubing or a crimp and seal connector. Technician B says to solder and use electrical tape. Which technician is correct?
A) Technician A B) Technician B C) Both technicians D) Neither technician
A
You might also like to view...
A ____ thermostat wire can cause a bad connection that will cause the compressor to alternately start and stop.
a. short b. loose c. long d. tight
A prime circle ____.
A. has a diameter equal to the diameter of the base circle added to the radius of the cam follower B. is only used in the construction of an inline follower plate cam profile C. passes through the center of the follower at the 0° position D. both a and c E. none of the above
If the first character of the VIN is an "S," where was the vehicle made?
A) England B) Mexico C) United States D) Canada
Why are the coils in an air-source heat pump referred to as the outdoor coil and indoor coil instead of the condenser and evaporator?
A) Because both the coils in a heat pump coils are identical. B) It can sometimes be difficult to determine the exact location of the coils. C) Refrigerant does not evaporate or condense in a heat pump coil. D) Their function (evaporator or condenser) reverses when the unit changes from cooling to heating.