Technician A says that the TP sensor signal voltage should be about 0.5 volt at idle and increase to about 2.5 volts at wide-open throttle (WOT). Technician B says that a TP sensor can be tested using a DMM (digital multimeter), DSO (digital storage oscilloscope), or scan tool. Which technician is correct?
A) Technician A only
B) Technician B only
C) Both technicians
D) Neither technician
B
Trades & Technology
You might also like to view...
Which of the following water treatment activities reduce turbidity? Select all that apply.
A) Sedimentation. B) Aeration. C) Disinfection. D) Coagulation.
Trades & Technology
Concrete that has hardened but not yet gained structural strength, is referred to as _____.
a. raw b. green c. uncured d. unstable
Trades & Technology
_________________ means connecting two objects together with metal.
Fill in the blank(s) with the appropriate word(s).
Trades & Technology
?As the percentage of carbon increases, ____ can cause hot shortness and porosity.
A. ?carbon B. ?sulfur C. ?phosphorus D. ?manganese
Trades & Technology