Why shouldn’t an electrical component ever be placed in a parallel circuit if it has a voltage rating less than the source voltage?

What will be an ideal response?


In a parallel circuit, each resistor is placed directly across the main source of voltage. This causes each resistor to operate at the same voltage as the source. Therefore, each electrical component in a parallel circuit must have a voltage rating greater than the voltage source.

Trades & Technology

You might also like to view...

When hands-on demonstrations or practice is not practical, you should _____.

a. skip over the portion of the training b. explain the procedure during the lecture c. use a simulator, video, or model d. cover the topic in a large group discussion

Trades & Technology

Larger sizes of calcium silicate may need to be secured with _____.

a. larger wires b. screws c. glass-fab tape d. metal bands

Trades & Technology

Pole buildings are a variation of ____ construction.

A. platform B. western C. post-and-beam D. balloon

Trades & Technology

The voltage divider network of Figure P2.52 is designed to provide vout = vS/2. However, in practice, the resistors may not be perfectly matched; that is, their tolerances are such that the resistances are unlikely to be identical. Assume vS = 10V and nominal resistance values of R1 = R2 = 5 k?. a. If the resistors have ±10 percent tolerance, find the expected range of possible output voltages. b. Find the expected output voltage range for a tolerance of ±5 percent.

Trades & Technology