If a tool is found to be damaged upon inspection for use, the correct next steps are:

a. To throw it away and find a replacement
b. To see if it is still functional and report it at the end of shift
c. To put in a requisition for a replacement and use the tool carefully
d. To label it “Do Not Use” and report its condition to the supervisor


a. Incorrect. If a tool is found to be damaged upon inspection, label it as “Do Not Use” and report its condition to the supervisor.
b. Incorrect. If a tool is found to be damaged upon inspection, label it as “Do Not Use” and report its condition to the supervisor.
c. Incorrect. If a tool is found to be damaged upon inspection, label it as “Do Not Use” and report its condition to the supervisor.
d. Correct. If a tool is found to be damaged upon inspection, label it as “Do Not Use” and report its condition to the supervisor.

Trades & Technology

You might also like to view...

c. 36 times greater than the OD of the conductor

a. A type of duct system b. A gasketed locknut c. A gasketed fitting d. An insulated bushing

Trades & Technology

The hypotenuse is 17 inches and the side opposite is 13 inches. Angle A is _____ degrees.

a. 42 b. 45 c. 50 d. 65

Trades & Technology

When a river cuts deeply into a floodplain to flow at a lower elevation, the old floodplain is called a

____.

a. river bank b. river terrace c. river delta d. river plain

Trades & Technology

A _________________________ is used when a symmetrical object requires sectioning and one quarter of the object is removed to create the section.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology