The depth of shoulders and steps machined in a workpiece held in a chuck are measured with:

A) Inside micrometer and spring joint caliper B) A hook rule or a depth micrometer
C) An optical comparator D) Tape measure and spring caliper


B

Trades & Technology

You might also like to view...

A(n) ____________________ point is the mid-point of a two-point measurement.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

Where are the largest muscles on the cat found?

A) the trunk B) the tail C) the front legs D) the rear legs

Trades & Technology

The cutting-plane line is a thick line representing the cutting plane and can be drawn using:

A. alternating long and two short dashes B. evenly spaced dashes C. alternating long and three short dashes D. a and b E. none of the above

Trades & Technology

The ____ control valve is especially designed for mixing applications.

A. single-sealed B. double-sealed C. three-way

Trades & Technology