In order to prime a typical fuel sub-system with a hand-primer pump that has to be installed into the circuit, where should it ideally be located?
A. close to the pick-up tube
B. upstream from the primary filter
C. upstream from the transfer pump
D. downstream from the secondary filter
Answer: A
You might also like to view...
What is the difference between high-pressure and low-pressure sodium lamps?
What will be an ideal response?
Engine operation is being discussed. Technician A says preignition can cause engine damage. Technician B says carbon deposits on the pistons can increase the compression ratio. Who is correct?
A. Technician A B. Technician B C. Both technicians D. Neither technician
Technician A says a Chrysler 36RH is a transaxle. Technician B says a Chrysler 31TH is a transaxle. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B
A proposed heat engine draws its input heat from a space at 1000 K and rejects the heat to a space at 400 K. The engine is to produce 300 kW of power from a heat input of 900 kW. Is this process possible?
Given: Proposed: TH = 1000 K; TC = 400 K; Q?H=900 kW; W?=300 kW