Which of the following is a typical step in the shutdown procedures for a steam turbine?
A. Adjust turbine speed.
B. Close the inlet valve.
C. Open the low-pressure steam valve slightly.
D. Verify the lube oil and cooling water are in service.
A. Incorrect. Closing the inlet valve to the steam turbine is a typical step in the shutdown procedures for a steam turbine.
B. Correct. Closing the inlet valve to the steam turbine is a typical step in the shutdown procedures for a steam turbine.
C. Incorrect. Closing the inlet valve to the steam turbine is a typical step in the shutdown procedures for a steam turbine.
D. Incorrect. Closing the inlet valve to the steam turbine is a typical step in the shutdown procedures for a steam turbine.
You might also like to view...
Which corner of the house will benefit from the cooling effect of a large tree planted nearby?
A) Northeast B) Southeast C) Southwest D) Northwest
Before the power factor of a motor can be corrected, what must be determined first?
What will be an ideal response?
A machined piece of steel is in the shape of a cylinder. There are two parallel holes drilled through the cylinder on the circumference. Which of the following is (are) true?
A. A revolved or removed section is the best application for sectioning this object. B. A section line is not necessary since the location of that line is obvious when the cylinder is viewed in section. C. Cutting plane lines are used in the view of the section of the cylinder to show where the cylinder has been cut. D. both b and c E. none of the above
The purpose of a lap joint is to:
A. reinforce the edge B. join two separate pieces C. roll the end of the material D. all of the above