Use the following information to solve problems 7 through 10. A drafter must determine several measurements before a gear can be drawn. These measurements are often found by using formulas. Most gear-cutting data can be found if the diametral pitch P and the number of teeth N are known. Given the diametral pitch P is 8, and the number of teeth N is 96, use the following formulas to solve the problems.a. Pitch Diameter D:  b. Outside Diameter O:  c. Addendum A: 

src="https://sciemce.com/media/4/ppg__examview__image32__00001_res__sa007-3.jpg" border="0">d. Thickness of the Gear Tooth T:    e. Depth of the Gear Tooth W:    Find the pitch diameter D.

What will be an ideal response?


12 inches

Trades & Technology

You might also like to view...

The architect’s 16 scale is equal to what fraction of an inch?

a. 16 b. 1/8 c. 1/16 d. 1/10

Trades & Technology

Places of assembly are buildings, or portions of buildings, designed (or intended) for the assembly of ____ or more persons.

A. 50 B. 100 C. 500 D. 1000

Trades & Technology

All custom products are more expensive than mass-produced products.

Answer the following statement true (T) or false (F)

Trades & Technology

Which of the following is true regarding the Auxiliary Power Outlet system?

A) The outlets are protected by 20-amp circuit protection devices B) The outlets use ground-fault protection circuitry C) Both A and B D) Neither A nor B

Trades & Technology