Which of the following is true of backhand welding?
A. It has good joint visibility and makes welds with less joint penetration.
B. It works well on vertical up and overhead welds.
C. It has good bead visibility and makes welds with deeper joint penetration.
D. It has a good balance between penetration and reinforcement and is used on automated welding.
Answer: C
You might also like to view...
If pus is present, the skin or nail is:
What will be an ideal response?
The heat of compression can be determined using:
A) The enthalpy difference from the beginning to end of the compressor line. B) The enthalpy difference from the beginning to end of the metering device line. C) The enthalpy difference from the beginning to end of the evaporator line. D) The enthalpy difference from the beginning to end of the condenser line.
An example of an open loop geothermal water source heat pump application would be a system connected to a
A) well B) vertical loop C) lake loop D) slinky loop
What does the "cure" for noise problems depend on?
A) the type of noise B) the path of noise into the circuit C) the source of noise D) all of the above