When the rear engine mounts are located on the flywheel housing, which of following must be done before removing an engine from the chassis?
A. support engine oil pan
B. support radiator assembly
C. support charge air cooler
D. support the transmission
Answer: D
You might also like to view...
What is the pumping member of a diesel engine water pump rotor known as?
A. propeller B. impeller C. turbo D. gearotor
A three-wire control circuit uses momentary contact, start-stop stations, and a holding circuit interlock connected ____ with the start button to maintain the circuit.
a. in tandem b. in parallel c. alternately d. in series
The hexadecimal number system is referred to as base ____.
A. 2 B. 8 C. 10 D. 16
In a heat pump, 15% of the heat is from the heat generated running the compressor. The rest is from the exchange of heat with the air or ground. How much heat is generated running the compressor of a 2-ton heat pump? (One ton is equivalent to 12,000 Btu/hr.)
Fill in the blank(s) with the appropriate word(s).