The NEC® article that lists the requirements for installing a service disconnect is _____.

a. NEC Article 110
b. NEC Article 210
c. NEC Article 220
d. NEC Article 230


d. NEC Article 230

Trades & Technology

You might also like to view...

Pressure switch circuits are ____ type switches.

A. transducer B. simple on-off C. sensor D. actuator

Trades & Technology

In a certain experiment, cylindrical samples of diameter 4 cm and length 7 cm are used. The two thermocouples in each sample are placed 3 cm apart. After initial transients, the electric heater is observed to draw 0.6 A at 110 V, and both differential thermometers read a temperature difference of 10°C. Determine the thermal conductivity of the sample.

What will be an ideal response?

Trades & Technology

Timing gears are being discussed. Technician A says that worn timing gears can make noise. Technician B says that the clearance between the gears that is seen by rotating one gear back and forth without the other moving is called backlash. Who is correct?

A. A only B. B only C. Both A and B D. Neither A nor B

Trades & Technology

Analog measurements that are based on two input voltages are called

A) differential. B) asymmetrical. C) asynchronous. D) dual input.

Trades & Technology