IAQ problems resulting from the creation of negative pressure areas in a building due to insufficient outdoor makeup air may be corrected by _____.
a. making sure the outdoor dampers are set to the closed position
b. gradually reducing the proportion of recirculated air being supplied
c. properly balancing the building’s air supply and the exhaust system
d. installing smaller boilers and chiller throughout the HVAC system
c. properly balancing the building’s air supply and the exhaust system
You might also like to view...
Where geometric tolerances, containing the MMC modifier are applied to a feature of size, its worst-case boundary is called a(n) ____________________.
What will be an ideal response?
In determining the total width of a movement joint between building components, we account for the dimensional and construction tolerances. Poor or inadequate quality control on a construction site
A) decreases dimensional tolerances. B) increases construction tolerances. C) increases dimensional tolerances. D) decreases construction tolerances. E) none of the above.
All 125V, single-phase, 15A and 20A general-purpose receptacles mounted in an area of an agricultural equipotential plane are required to be of what type?
a. Twist load b. Arc fault c. Tamper resistant d. Ground fault circuit interrupter
What recently introduced valve management technology enables compression ratio management?
A. Non-lashing valves. B. Valve rotators. C. Variable Valve Timing (VVT). D. Valve harmonics.