How would you remove a third member from a banjo housing?
What will be an ideal response?
The axles must be pulled before you can remove a third member from a banjo housing. First, drain the gear oil from the housing. Then remove all of the nuts from the studs around the outside of the third member. There is often a copper washer under each nut that can be hard to see through the layer of grease and dirt. The third member cannot be removed from the housing until all of the washers have been removed. Use a sharp scraper to carefully remove each washer.
You might also like to view...
When pressure testing a hydraulic assisted power steering system, the highest pressures were greater than 50 psi of each other. This indicates a problem with ________
A) The pump rotor B) The flow control valve C) The pump vanes D) A defective hose
Electronic duty switch contacts are designed to switch high currents and pilot duty contacts are more suited for switching very small current levels
Indicate whether the statement is true or false
?Plasticizer leaching or loss is an important consideration in terms of ____.
A. ?increasing opacity B. ?resistance to insects C. ?contact with food D. ?compatibility with resins
A CVT uses belts and pulleys, instead of gear sets, to provide changing drive ratios.
Answer the following statement true (T) or false (F)