Draw the site plan shown on the back of this sheet according to the following information:
a. Use AutoCAD to recreate the engineer’s sketch using correct drafting practices.
b. Fully dimension the plan according to the practices described in-class.
c. Use correct layers according to the AIA CAD Layering Guidelines.
d. Include the drawing title, north arrow, graphic scale, and complete lot and block legal
description.
e. Plot the drawing using an appropriate sheet size and drawing scale. Include a complete
border and title block. Plot using the Autodesk-MONO plot style.
f. You can use the FINAL TEMPLATE available in the class folder of the instructor drive, to
complete this problem.
g. You can use any blocks available in the FINAL TEMPLATE file, and any symbols and
blocks you have created in this class.
h. Your grade is based on the successful completion and correct use of the following:
? Drawing geometry according to the sketch
? Dimensioning and annotation practices
? Border and title block
? Drawing scale (you must choose the most appropriate scale)
? North arrow
? Graphic scale
? Title
? Legal description
? Layers: line types, line weights and line type scale
? Overall appearance
You might also like to view...
All of the following are bi-fuel combinations except:
A. Gasoline and CNG B. Propane and gasoline C. E85 and gasoline D. CNG and diesel
To insure that the band set is adequate for a specific contour cut, you should make a test cut on:
A) A scrap of the same material and thickness as the workpiece B) Thin sheet metal C) A piece of wood D) The workpiece
The relationship between energy, work, and power can be stated as which of the following?
A) Work is required to convert energy into power. B) Power is required to convert work into energy. C) Power is measured in units of energy, and work is the transfer of power. D) Energy is the ability to do work, work is the result of transferring energy, and power is the rate at which the work is accomplished.
The subsequent problems deal with the 2-bit A/D flash converter shown below where Vmin is 0V and Vmax is 4V. Assume the comparators have standard TTL outputs (not open-collector).If Vin is 1.5V and trigger is high, what is G2?
A. 0 B. 1