If the previous command was G90 G00 X5 Y6 Z3, which of the following commands will cause the tool to move to (8,8,3), moving at the currently set feed rate:

A. G01 G91 X3 Y2
B. G01 G90 X3 Y2
C. G00 G90 X8 Y8
D. G01 G91 X8 Y8 Z3


Answer: A

Trades & Technology

You might also like to view...

The joints between the phalanges are classified as

A) sutures. B) condyloid. C) hinges. D) gomphosis. E) saddle.

Trades & Technology

Increasing the airflow across a filter:

A) Increases its efficiency. B) Decreases its efficiency. C) Will reduce the air noise across the filter. D) Has no effect on filter efficiency.

Trades & Technology

Technician A says that to adjust steering toe, one of the crosstube tie-rod ends must be removed from an Ackerman arm so that it can be rotated. Technician B says that a tie-rod crosstube has left-hand threads on one side, and right-hand threads on the other. Who is correct?

A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B

Trades & Technology

Each signal in Figure E-49 is graphed over a range of exactly one fundamental period. Which of the signals have harmonic functions that have a purely real value for every value of k? Which have a purely imaginary value for every value of k?

Trades & Technology