Where does a wrist pin fit to a piston?
A. upper ring land
B. piston crown
C. pin boss
D. lower oil control groove
Answer: C
You might also like to view...
The Acceptance Criteria for Bend Test requires that no single indication shall exceed ____ in. measured in any direction on the surface.
A. 1/8 B. 2/8 C. 3/8 D. 4/8
A cable is made up of four wires. The breaking strength of each wire is a normally distributed random variable with mean 10 kN and standard deviation 1 kN. The strength of the cable, using the brittle wire method, is estimated to be the strength of the weakest wire multiplied by the number of wires.
a. Use simulated samples of size 1000 to estimate the mean strength of this type of cable. b. Estimate the median cable strength. c. Estimate the standard deviation of the cable strength. d. To be acceptable for a certain application, the probability that the cable breaks under a load of 28 kN must be less than 0.01. Does the cable appear to be acceptable? Explain.
The step response of an RLC circuit is given by  figure 1.png)
Given that i(0) = 18 amps and di(0)/dt = 36 amps/sec, solve for i(t).
What will be an ideal response?
Technician A says that the EGR system controls and monitors fuel vapor loss. Technician B says that the EVAP system controls and monitors fuel vapor loss. Who is correct?
A. A only B. B only C. both A and B D. neither A nor B