The total movement of the cam follower in one complete revolution of the cam is called:
a. dwell
b. displacement
c. rise
d. fall
b. displacement
You might also like to view...
What is the reason most manufacturers suggest that a valve bridge be removed from the engine before backing off the adjusting screw?
A. adjusting screw is easily damaged B. bridge may be deformed C. bridge guide is easily bent D. rocker may be damaged
This output device sprays droplets of ink onto the paper to form dot-matrix images.
a. laser printer b. electrostatic plotter c. inkjet printer d. dot-matrix printer
Which of the following statements is LEAST-Likely true?
A. If tires are to be replaced, the new tires should be installed before attempting an alignment. B. When correcting for road crown, camber creates less of a pull than caster. C. Caster causes the camber angle of the wheel to change during a turn. D. Roads are crowned (higher at the center than the outside) so that rain will run off.
What does a variable timing device such as Econovance allow an ECM managing a Bosch 8500 injection pump to control?
A. exact moment of ignition B. injection timing advance C. centrifugal timing advance D. engine cylinder pressure