This is a condition when, due to the limits of dimensions, there is always clearance between mating parts.
a. clearance fit
b. allowance
c. interference fit
d. maximum material condition
a. clearance fit
Trades & Technology
You might also like to view...
The instantaneous direction of current at a specific moment is known as _____.
a. hysteresis b. polarity c. impedance d. internal resistance
Trades & Technology
What was the transistor density per inch of a modern microprocessor chip used in desktop computers?
What will be an ideal response?
Trades & Technology
When work is completed under the original estimate, the major problem is _____
a. material costs are not accurate b. poor historical data c. bids are not competitive d. profits are limited
Trades & Technology
According to Ohm's Law, if voltage were to decrease while resistance remained the same, current would
A) decrease B) no way to determine C) increase D) remain the same
Trades & Technology