Technician A says residual fuel pressure should maintain above 21psi for 5 minutes. Technician B says residual fuel pressure should maintain above 26psi for 10 minutes. Who is correct?
A.)Tech A only
B.)Tech B only
C.)Both Tech A and Tech B
D.)Neither Tech A nor Tech B
Answer is A.)Tech A only
You might also like to view...
Repeat Problem 1–13. Does the data reflect the number found in part (b)? If not, why? Plot a histogram of the data. Presuming the distribution is normal, plot Equation (1–4) and compare it with the histogram.
Determine the tensile and yield strengths for the following materials: (a) UNS G10200 hot-rolled steel. (b) SAE 1050 cold-drawn steel. (c) AISI 1141 steel quenched and tempered at 540°C. (d) 2024-T4 aluminum alloy. (e) Ti–6Al-4V annealed titanium alloy.
Pump curves are drawn for different impeller diameters, for a given rotation speed, fluid, and temperature, and show flow versus ______.
Fill in the blank(s) with the appropriate word(s).
When performing an open-root V-groove weld in the 1G position, the drag angle should be _____
a. 1 to 5 degrees b. 5 to 10 degrees c. 10 to 15 degrees d. 15 to 20 degrees
A _____ is an electrical circuit that contains two or more paths for the electricity or signal to flow from a common source.
A. ground fault circuit interrupter B. receptacle C. single-pole circuit D. parallel circuit