When the drive gear has a smaller diameter and fewer teeth than the driven gear, it is referred to as ________.
A) Direct drive
B) Speed multiplication
C) Gear reduction
D) None of these is correct
C) Gear reduction
Trades & Technology
You might also like to view...
When weld symbols are placed on both sides of the reference line, the welds can be made on either side of the joint.
Answer the following statement true (T) or false (F)
Trades & Technology
The windings are located in which part of the motor?
A. rotor B. stator C. either a or b D. it depends on the type of motor
Trades & Technology
What causes wet liner cavitation?
A. engine overheating B. engine lugdown C. bubble collapse D. air in coolant
Trades & Technology
Describe the characteristics of concrete block cores.
What will be an ideal response?
Trades & Technology