Which of the following is true of the flat outside corner joint?
A. It must be made with the addition of filler metal.
B. It is one of the most difficult to make.
C. If the sheets are tacked together properly, filler metal is needed.
D. If filler metal is added, it should be added uniformly.
Answer: D
You might also like to view...
When conducted properly, which of the following will indicate faults such as cracks, discontinuity, thin spots, and faulty terminations?
a. Insulating test b. Hi-pot test c. Proof test d. DC test
What is the vapor pressure of propane at T = 275 K, according to the shortcut equation?
A. 117 kPa B. 0.502 MPa C. 1.67 MPa D. 2094. MPa E. None of these.
A customer complains that the heater works sometimes, but sometimes only cold air comes out while
driving. Technician A says that the water pump is defective. Technician B says that the cooling system could be low on coolant. Which technician is correct? A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B
In the classic three op-amp instrumentation amplifier, the differential voltage gain is usually produced by the:
A) second stage. B) first stage. C) output op amp. D) mismatched resistors.