Numbered symbols used on the floor plan key specific items to charts known as:

A. lists
B. charts
C. tables
D. schedules
E. none of the above


Answer: D

Trades & Technology

You might also like to view...

When assembling U-bolt wire clips, the saddle should be positioned so that it is _____.

a. on the side opposite the nuts b. parallel to the wire rope c. against the dead end of the wire rope d. against the live section of the wire rope

Trades & Technology

Which of the following must be located during failure analysis investigation if a repeat is to be avoided?

A. coincidental damage B. warranty report C. policy adjustment D. root cause

Trades & Technology

The hourly heat loss of a building is needed in order to _____

a. select zone valves b. find the head pressure of a pump c. determine pipe friction losses d. find the required heating water flow rate

Trades & Technology

Which of the following would NOT cause a high pressure fault?

A. Fan drive failure B. Evaporator blockage C. Condenser blockage D. Refrigerant overcharge

Trades & Technology