The location tolerance specifies the amount that ____ of the feature is (are) allowed to deviate from true position.

A. axis
B. boundaries
C. surface
D. circularity
E. none of the above


Answer: A

Trades & Technology

You might also like to view...

This drawing is a representation of ________.



A) A potentiometer
B) A relay
C) An ignition coil
D) A vacuum switch

Trades & Technology

Glycol solutions are added to water in secondary refrigerant loops

A) To lubricate the circulating pump bearings B) To increase the system heat transfer C) To make leaks easier to locate D) To prevent freezing and inhibit corrosion

Trades & Technology

In what year was the PCV system monitor added to the list of major monitors?

What will be an ideal response?

Trades & Technology

The readings shown above were recorded during an injector balance test. All of the following symptoms are consistent with the test results EXCEPT:

Trades & Technology