What parts of the Toyota and Ford hybrids are not rebuildable and are replaced as units if they fail?
A. MG1and MG2
B. oil pumps
C. carriers
D. transaxles
Answer: D
You might also like to view...
Technician A says that instrument panel illumination may be controlled by a rheostat. Technician B says that instrument panel illumination may be controlled by pulse width modulation. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B
PROBLEM 3.54 The composite shaft shown is to be twisted by applying a torque T at end A. Knowing that the modulus of rigidity is 11.2 × 106 psi for steel and 4 × 106 psi for aluminum, determine the largest angle through end A may be rotated, if the following allowable stresses are not to be exceeded: ?steel = 8000 psi and ?aluminum = 6000 psi.
Receptacles must be installed so that no point measured along the floor line in any wall space is more than __________ feet from a receptacle.
a. 3 b. 6 c. 10 d. 12
Which of the following statements concerning applications or capabilities of soil moisture measuring devices is (are) true for the use of a drying oven and balance?
A) requires "destructive sampling" for each measurement B) good to turn on automatic irrigation at -5.0 kPa C) used to turn on irrigation when soil moisture potential reaches -20.0 kPa D) gives same reading for loamy sand and silt loam if both contained 15% moisture E) both A and D