The __________ control mode is used to overcome offset.

A. rate
B. reset


Answer: B

Trades & Technology

You might also like to view...

Answer the following statement(s) true (T) or false (F)

1. Employment opportunities for qualified electricians are currently decreasing. 2. The student electrician should be a high school graduate or equivalent. 3. Electricians usually work alone.

Trades & Technology

When installing a bearing over a shaft, where should the force be applied?

A) On the ball bearings themselves B) On the outer (outside) race C) On the inner (inside) race D) On both the inner and outer races

Trades & Technology

Seed potatoes are cut into pieces for planting

Indicate whether the statement is true or false.

Trades & Technology

In the thread specification 1/2-14 NPT, the NPT stands for ____________________.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology