When teaching to lead, do not do which of the following?
A. jerk hard on the halter or lead
B. use an electrical shock or prod device
C. tie the calf to a motor vehicle
D. all answers are correct
Answer: D
You might also like to view...
PROBLEM 2.12
A block of 250-mm length and 50 ? 40-mm cross section is to support a centric compressive load P. The material to be used is a bronze for which E = 95 GPa. Determine the largest load that can be applied, knowing that the normal stress must not exceed 80 MPa and that the decrease in length of the block should be at most 0.12% of its original length.
What determines the efficiency of a Stirling engine?
What will be an ideal response?
Starting with an energy balance on a rectangular volume element, derive the one-dimensional transient heat conduction equation for a plane wall with constant thermal conductivity and no heat generation.
What will be an ideal response?
A circle that is at a 15-degree tilt will resemble an ellipse.
Answer the following statement true (T) or false (F)