The term used for sizing equipment is __________.
A. load calculations
B. BTU/H
C. internal loads
D. cooling/heating
Answer: A
You might also like to view...
Are soluble salts compounds of sodium, calcium, and magnesium that dissolve in water?
Indicate by YES (Y) or NO (N).
What could be the problem if a noid light remains on (does not flash) with the engine cranking?
A) Short to ground in the injector ground circuit, or defective PCM B) Blown injector fuse C) High injector resistance D) Low system voltage
Which statement is true regarding the internal grids in automotive batteries?
A) The lead used to make the grid is enhanced with other elements for durability B) The grid is made mainly of lead C) Both A and B D) Neither A nor B
When performing a reservoir leakage test, what is considered a maximum acceptable air loss rate for a tractor/trailer combination vehicle?
A. 6 psi (40 kPa) in 2 minutes B. 6 psi (40 kPa) in 1 minute C. 2 psi (14 kPa) in 2 minutes D. 2 psi (14 kPa) in 1 minute