Part number 113 is a reinforcing pad. Specifically describe how it is attached to H2 and how it is attached to the 12” Sched. 80 S Pipe.

Refer to Drawing Numbers T6592ML R0, T6593ML R0, and T6594ML R0.


It is attached to H2 by a 1?4 inch fillet weld arrow side, all around – It is attached to the schedule 80 pipe by 3 welds consisting of a single bevel on both sides of the joint both with 1/16 inch root opening, 45 degree groove angle welded all around and a 3/8 inch fillet over the bevel groove on the arrow side.

Trades & Technology

You might also like to view...

A(n) ____ is the set of rules and configuration guidelines governing the implementation and operation of IDPSs within the organization.

A. attack stimulus B. confidence C. site policy D. IR policy

Trades & Technology

In the above figure, when the start button is pressed, the N.O. CR contacts ____________________ (open, close) and the current through the armature ___________________________________ (flows through the resistor, is supplied through the motor control circuitry).

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

_____ is an example of an insulating material

A) Water B) Copper C) Glass fiber D) Iron

Trades & Technology

A ____ is two or more numbers used to express a unit smaller than one.

A. fraction B. decimal fraction C. whole number D. mixed unit

Trades & Technology