Technician A says that the diameter of a bolt is the same as the wrench size used to remove or install the fastener. Technician B says that the length is measured from the top of the head of the bolt to the end of the bolt. Which technician is correct?
A) Technician A only B) Technician B only
C) Both technicians A and B D) Neither technician A nor B
D
You might also like to view...
Figure 39-2
When the START button is pushed in the accompanying figure, relay coil CR is energized. This causes all CR contacts to close. Contact CR-1 is a(n) ____________________ used to maintain the circuit to coil CR when the START button is released.
Fill in the blank(s) with the appropriate word(s).
When mowing a lawn, how much of the top should be removed at any one mowing?
A) One-half of the top B) One-third of the top C) One-quarter of the top D) Three-quarters of the top
There are several reasons for the manager to seek input from employees to help the manager make an informed decision on certain projects. List three
What will be an ideal response?
Oblique drawing can be drawn at angles other that ______ degrees.
Fill in the blank(s) with the appropriate word(s).