What is the direction of lay required based on the symbol shown in Figure 5?

a. Parallel

b. Perpendicular

c. Radial

d. Multidirectional

e. None of the above




b. Perpendicular

Trades & Technology

You might also like to view...

The component labeled 1 in the figure below is a(n) _____.

a. end seal b. power connection c. splice/tee connection d. thermostat

Trades & Technology

Levels make use of a glass tube filled with a ____________________

Fill in the blank(s) with correct word

Trades & Technology

The compressor ina system operating with noncondensable gases:

A) Runs cooler than normal. B) Makes a whistling noise when it shuts off. C) Runs hotter than normal. D) Has an unusually low amp draw.

Trades & Technology

Which of the following is not a basic element of the Ethernet system?

A) Physical medium B) Set of medium access control rules C) Set of logical topologies D) Frame that consists of standardized set of bits

Trades & Technology