The measured voltage on the secondary of a given transformer is 0 V. Which of the following could have caused this?
A) shorted load B) open secondary C) open primary D) any of the above
D
Trades & Technology
You might also like to view...
Heavy-duty shock absorbers are pressurized with nitrogen gas to a pressure of:
A. 180 psi B. 260 psi C. 360 psi D. 540 psi
Trades & Technology
Examine this diagram. What temperature and mode has been selected?
A) Hot, heat at defroster vents
B) Hot, heat on floor
C) Cold, air coming out dash vents
D) Warm, cool air at defrost vents
Trades & Technology
Match the gas law with its properties.
A. P1 × V1 = P2 × V2 B. V1 / T1 = V2 / T2 C. PTOTAL = PSUBSTANCE 1 + PSUBSTANCE 2
Trades & Technology
When digital logic or other designs that use high-pin-count chips are used, ____ trace layers are required.
A. one B. two C. four D. more than four
Trades & Technology