When the amount of material to be removed by machining is specified, a numerical value is placed:

A. To the right of the machining symbol.
B. To the left of the machining symbol.
C. Above the "V" of the machining symbol.
D. Wherever is most convenient.


Answer: B

Trades & Technology

You might also like to view...

The dome lamps will not switch off when both doors are closed on a truck. Which of the following could be the cause?

A. Shorted to ground circuit between the dome lamp and the door switches B. Left side door switch is remaining closed with door closed C. Right side door switch is remaining closed with door closed D. All of the above could cause this problem.

Trades & Technology

18. ____________ are hollow tubes used to conduct electromagnetic energy at microwave frequencies

A. Antennas B. Transmission lines C. Cables D. Waveguides

Trades & Technology

Solid stone counters are very durable; however, the stone is also porous and should be ____ periodically.

A. waxed B. polished C. painted D. sealed

Trades & Technology

 ______________ is simply air pressure below atmospheric pressure.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology